FUEL TRANSFER SYSTEM
Our qualified engineers can offer the best solutions for the fuel transfer system with best logic for controls. P & ID, Piping isometric and other drawings are designed in-house. Our stock of specialized material / gauges, sensors / controllers and transmitters of diesel
system is normally enough to meet the most requirements. Special design can also be done on request. Fuel tanks are fabricated to meet BS Standard BS-EN12285-2.2005. Rectangular and Cylindrical tanks up to 50,000 Liters in single and double wall construction are done to meet the reqmts. All fuel transfer lines are compressed air tested to ensure free leakages and safe to operate after installation.
Our experience list and major project reference are available on request.
DESIGN & ENGINEERING
We assist to customize your requirement on sizing of gen-sets, design of layout for gen-set and fuel transfer system, selection of material, support calculation for back pressure on system, thermal calculation, noise level calculation and load analysis etc. Our qualified
engineers are capable to design and meet even most stringent specification within limitation of site.
Detail engineering and design drawings and assistance are available on request for major projects.
York Power Generation & Fuel Transfer System Erection / Installation industry’s best qualified and experienced Engineersand Technicians, Certified Welders & Fabricators. We ensure and follow highest safety standards and best quality materials to suit the application even on stringent specifications. York Technical is involved in following Genset Installation procedure to meet international standards and industry's best method..
RIGGING & ANCHORING
The rigging of Genset is carried out by experienced site staff with special tools, forklift, crane and even with specially custom fabricated platform to meet the requirements of the site. Safety is the main criteria of this operation.
SOUND ATTENUATION & COOLING SYSTEM
In-house design is done for the sound attenuation and cooling system to ensure compliance to BS and applicable international standards. Sound attenuation to customer specified limit is achieved using specially selected and designed attenuator / accoustic louvers. Sound attenuator complies DW144/142 and tested to BS 4718 standard..
EXHAUST PIPE WORK
Exhaust pipe work with standard BS standard pipes on floor, ceiling or wall supports to suit the site requirement with allowance for thermal expansion in consideration to flue gas temperature, drain and vibration absorption is designed and done by our most experienced staff.
THERMAL INSULATION & CLADDING
Thermal Insulation and Cladding of Industrial equipments / Installations are one of the core activities of York Tech.
Service Co. LLC.We employ a wide range of thermal insulation materials in combination with aluminum, stainless and galvanized steel cladding, to ensure the specified
surface temperature limitations. Our services include Insulation and Cladding Solutions for Process Industries / Power Plants / Pipeworks / Tanks / Process equipments / Boilers and Flue Ducts
POST INSTALLATION TESTING
Our design and installation of Gensets are supported by following measurements on commissioning of generators:
a. Anemometric measurement of air velocity at intake and discharge.
b. Exhaust and insulation temperature measurement with IR thermometer.
c. Noise level measurement.
d. Compressed air leak test on fuel lines and Load bank test on gen-sets etc..
STEEL STRUCTURE FABRICATION / MACHINING WORKS
Our fabrication division with the capability to design, manufacture and install steel works for Industrial, Commercial & Building industry employs engineers and designers / draughting staffs fully trained to international competency standards in modern design / drafting techniques.
OUR FABRICATED PRODUCTS INCLUDE:.
Ladders & Handrails Ducts
Tanks & Vessels
Pipe Clamps & Pipe Supports